HID fog lights install Q's on an SC300/400

To make it less confusing.  I have a 95 SC400, and I am doing a 97 conversion.  So the fog light harness is the same.

Whats different is the bulbs.

The OEM and Nokya H3 bulbs I had in my 95 were shorter than the HID H3 bulbs.

The OEM and Nokya H3 Bulbs had a short heat wrapped wire on it vs. The HID bulbs have two big wires with snap clips than mates to the wires on the Ballast.

The other wire on the ballast have flat ends, that I guess is supposed to mate to the cap and or stock harness?

Basically it seems like the cap won't fit back on the housing. and the flat ends need to be modified to fit the cap and harness?

drill holes through the cap. and did you get the correct plugs for the h3 stock harness? because i have yet to be able to find somewhere that makes a nice plug, rather just terminal style pin/plugs.

Charley

ok I see.  The kit does have the spade ends, so I might have to do the terminal route.  The hole is gonna be to the side cause of the wire harness clamps can't fit through it