y33 Active Suspension Bypass?

i was wondering what the guys with the Q45t and Q45AE did with the active suspension when they swapped out for new suspension.  is it as simple as tying off the connectors and pulling a fuse or is there more to it than that?

:dunno:

I would just remove the actuators at the plug and zip tie the wires out of the way. They have a connector on the end, so it's not like you have to worry about them grounding out. But, I would probably electrical tape them up just in case you want to go back to stock and don't want them to corrode.

Yea it's that simple, mine are jus disconnected
nothing more, nothing less

well alright then.  just figured i'd ask so i don't run into problems later.  thanks!