ls400 rims

i have been looking at getting a set of rims for my 94 ls400 and i was wondering if 9x11.5+11 will fit in the rear. if not how much would i have to pull how far are they going to stick out? i have been reading up on how offset works and stuff but i still have a little touble figuring out what a good offset is for my car.
thanks

You will have to first max out your camber in the rear, then roll and pull... then once it starts to flare out, your almost there.... you won't be able to tuck them unless you cut and weld. You should be able to get them flush....

alright, thanks alot. i didnt think that they would require that much work. if i wanted to tuck what size/offset would you recomend?
thanks

you want to tuck rim on stock body? no rolling or pulling?...if so, a 10" +38 is conservative...
 
just a simple roll...do a 10" +15...

no, i dont mind pulling, but from what mista808 was saying it seemed as though with those rims i would have to pull quite a bit. say i got 19x10 with the same offset rolled and pulled would i still have to cut and weld to be able to tuck and what would i be cutting and welding? inner wheel well wall?