Thread #20290
Im going on coils. Do I have to do anything different before taking out my OEM air suspension?
you just have to disable the air compressor. this can be done by pulling out the fuse and you should be good to go
yep, thats it
If I pull the fuse when the car is on park will it release all the air out of my suspension?
no it will not, it will only keep the compressor from turning on again.
Is there a way to release all the air out with out breaking the line.
loosen the air fitting right at the strut... or fine the valve body and pull the line from there. rear valve body is next to the gas tank, front is in front of the passenger front wheel behind the liner...
mista808;298760 wrote:loosen the air fitting right at the strut... or fine the valve body and pull the line from there. rear valve body is next to the gas tank, front is in front of the passenger front wheel behind the liner...
[QUOTE=mista808;298760]loosen the air fitting right at the strut... or fine the valve body and pull the line from there. rear valve body is next to the gas tank, front is in front of the passenger front wheel behind the liner...[/QUOTE] I Just installed a Datasystem controller on my LS. When I lowered the back to my ride hight. The passenger rear sits 1/2 inc higher than the driver side rear. Some one said that there is a sensor that you can adjust to fix that. Would you happen to know where this sensor is or anyone on the board.
hey guys, can someone say where this compressor fuse is ??? thanks!
it should be located in the fuse box either inside the engine bay or the kick panel