Galant wheels

hiya guys well im looking for some help, over here in the UK we have a very limited supply of crazy dished wheels, u guys seem to have a surplus! i have a Legnum VR4 which is a jap import estate version of the galant.

iv been searching and searching the forums, i found this

[URL]http://vipstylecars.com/forums/attachment.php?attachmentid=1837&d=1237287633[/URL]

which without a doubt is the look i want to go for, judging by the thread and lack of OP

[URL]http://vipstylecars.com/forums/showthread.php?t=16559&highlight=galant&page=3[/URL]

i doubt anyone is going to be able to help me with questions about his suspension, or offset or anything else!

he is running 11*20 and 9*20, i need this shit!

im already on Tein coilovers so ride height is adjustable. my biggest issue is my 4wd, basically i will have to be very careful with my tyres to make sure my rolling radius is pretty much identical!

i like his wheels but am still undecided, definately want massive dish and crazy camber, but where should i be looking for wheels? and does anyone want to hazard a guess at offsets! lol

hoping you guys can really help me out!!

Darren

i see he listed his wheel specs on the first page, with offsets.
good luck with your search. i want to see it finished the way you want

i dont think he has, he states he is running 20" i forged techniks 9+11, but if u check his tyre sizes of 235 and 255 i think he is saying he has 9's up front and 11's on the rear.

what sites do u guys surf when looking to buy wheels like this?

i had a galant before i was running 19x 8 +37 on them sits flush on the front with some camber and some spacers on the rear 19x9 +37. and this was raise up cause it was a daily
 
[IMG]http://i303.photobucket.com/albums/nn136/nokcy21/P73013341-1.jpg[/IMG]

do you know how big the rear spacers were bud?

the wheels look like a good fitment, and the sort of fit im after, would very much so help me identify the offset im looking for!

not suire if im getting this the right way round or not but here goes.  so you was running +37 rear and for arguments sake a 10mm spacer, which gave you a +27??

so by adding 2" to the wheel width and trying to get them to sit where yours do, ill want roughly et0??

but then i want to add some crazy camber, so maybe ET-10-20mm ??  is this even close to being right!!  lol

im pretty sure our suspension is not the same as yours but i could be wrong

yeah i think it is diferent, mine is a jdm spec car

ok this is running 17*9 et28

[IMG]http://img412.imageshack.us/img412/9263/openrace020808527.jpg[/IMG]

so im guessing nokcy was running maybe 10mm spacer on the rear.

im quite confident i can run 10*20 all round and if im right with a et20 ill be 21 mm further out than this black one which i can hopefully pull in with some neg camber.

id really like some special wheels that arent available over here in the uk, would love to see some suggestions from you guys and ill attempt some photoshops.

i do have impressive front brakes and would ideally like them to be shown off. any help will be gratefully recieved

well you wont get much love over here since its a galant you might wanna go to our site thegalantcenter.net
 there are some guys there that know their stuff

cheers buddy, on route now

yeah i wa running 10mm on rear.