Work Euroline DH + spacer

Having some problems getting a set of 10mm spacers with studs fitting on my Work Euroline DH rims. Trying to see what options I have here.

The back of the rims have pockets for the studs. However, the two triangular pockets are blocking the new studs on the spacer. Once the spacer is on, 2 studs on the spacer does not have enough room to go through. The other 3 studs will clear.

Any help will be appreciated. Thanks!

[IMG]http://i51.tinypic.com/j83337.jpg[/IMG]

[IMG]http://i54.tinypic.com/14v49c6.jpg[/IMG]

[IMG]http://i52.tinypic.com/2l9m9mc.jpg[/IMG]

dual drill is the problem. buy spacers with replacment studs.

^^ agreed and I feel that replacement studs are safer than those with built in studs.

anytime you have dual pattern or slow disk wheels. you can't really use these type of spacer unless the thickness is 25mm and up

Damn I'm thinking I'm gonna run into this problem I have some riverside mae's with dual pattern I'm going to need to run spacers up front what spacers am I going to need??

Ah, I figured I had to change out the studs. Don't want to do that though. 

Any other options? 25mm spacer would be pokin out too much.

Not really?

You could have the rims machined (welded in) to remove the 4stud option, then cut to open up the pockets. Would be costly..
Or cut the studs real short (just long enough to get the spacer to bolt on), so they dont poke out the other side. Once again, not a brilliant move as then you can't ever bolt a normal wheel to it again.

Better off just getting replacement studs and going that route.