y33 ABS sensor

this may sound like a noob question but i'm trying to install my new set of BC coilovers but in doing so i can't seem to figure out on how to remove the abs sensor from the original spindle. can somebody please guide me to the right direction?

It should just pull out, try to wiggle or spin it until it starts to loosen. They are pretty fragile from what I remember though so be careful with it.

before even that remove the bolt holding it in.   probably a 10mm but could be a 12mm bolt.  After just wiggle it out.   If you want to be able to see it on the inside take the rotor off.  I think it was a 14mm bolt you put into the top hat and screw it in to get the rotor off the hub.   you will be able to see the sensor itself hovering over the hub teeth.

i have everything removed and the only stopping me from removing the strut is the abs sensor. i figured it would be as simple as to pulling it out but the sensor is being a really stubborn.

*thanks

spray some lube like PB blaster or WD40 and let it soak.  It's probably all the road grime and the spindle itself rusting and kinda fussing with the plastic.   Try using a channel lock with a towel and wiggle it out from the back side.  be gentle.