Anyone had any issues running adapters on stock studs?

Got some wheels for silly cheap but need some adapters to run them. So not spacers. Anyone had the studs snap running adapters?

no never. even running -11.5 camber. if you over tighten them you could break the studs. And dont buy some crap made ones to save money
.

Agree with mowgli. You wont have problems unless you buy cheap ones.

Mine snapped but I just replaced them with the crap studs and over torqued them im sure. Buy ARP's or factory studs. I run 1.25" adapters with VMR710's just fine. I even ran BMW 750 wheels which are 19x10 in the rear with the same adapters. Agreed on posts above 1.) no cheap studs or adapters 2.) install them correctly

I personally only run project kics spacers, the quality of them is bar none.

I also wouldn't run anything larger than a 30mm those sketch me out (no known failure, I just don't like that shit lol)

I picked up some 1.25 inch adapters. We will see if the wheels break off.

[QUOTE=MoWGLi;493640]I picked up some 1.25 inch adapters. We will see if the wheels break off.[/QUOTE]

Hahaha! best answer ever.