need help w/ fitment

Hey guys, newbie here running a 2000 Q45T.  My stock setup is on 17" with a 30 offset i believe.  I plan to run springs for awhile until air runner but I'd always ride at about 2-2.5" drop.

Whats the lowest offset i can run w/o rubbing or having to pull/roll the body if i have 

19 " wheels x 8.5 in the front and 9.5 in the back, how many inch lip would that give me?

trying to get the most dish as i can w/o modding the body

thanks guys

those cars have a  lot of room to play with offsets....search around and check the wheel  fitment thread because you can run single digit offsets front and rear on a 19x9/10 setup

Can't tell you much about the lip size, as this will vary 
widely depending on if it's a one-piece cast wheel, 
three-piece forged wheel, etc.

Another one of those "how crazy can I get without 
doing any mods" posts... 

Boo! Wrong website, dude!

i plan on goin with some ame shallen lx, doesnt have to be crazy, jus wonderin what offset i need b/c i dont have any knowledge of that, can you direct me to an informative site?

just noticed that roll/pull of fender is req when people go with crazy offsets and low low drop, i dont need it to the ground when i ride

not looking for that crazy stance, i dont like camber, just right fitment

also uncertain about hi or lo disc specs, noticed that sometimes with certain wheels

thanks

depends on what your looking for i guess..... personally i think pancakes set up is pretty sick!!!!