Please help me!!! Fender rolling problem

I need help with rolling my rear fenders on my 1997 Lexus ES300. Can someone please tell me how to roll my rear fenders without cracking the paint. I'm only running a set of 18x9.0 wheels and I cambered my rears -3.5 (SO FAR) with only a 2" drop for the time being till my coilovers come in. So can someone please tell me how to roll these fenders with out cracking my paint. 
 
Thanks,
Jerry (Intezza)

just cut it. you'll regret rolling it after it leaves creases where the fender gaurd use to be at. thats if you decide to roll it all the way flat. toyota's = cut

ya just cut it out, find a expierenced body shop. It usually cost like 30-50 to shave them off.

Thats what I was thinking also but I wasnt sure.

if you do decide to do it yourself, use a heat gun and take your time..... dont try and roll it flat in like 4 passes. each corner should take you, i estimate about 45mins- 1hour. and uses plenty of heat to prevent paint cracks... good luck

Thanks everybody for all the help comments I know what I need to do know.

i thought you couldnt cut the fenders on lexus do to the spot welds??

Many people shave the fenders, but oftentimes forget to reweld the spot welds.  To be done properly (in order to maintain structural integrity) the spot welds should be redone after the fenders are shaved.  This is why rolling/pulling is suggested against cutting by some people.